The page requested is not available.

 

Welcome to the Shop

We are specialized in racing parts and rare parts for Fiat, Fiat 500 /600, Abarth , Abarth 1000 TC / R Fiat 850 / OT , Autobianchi, Lancia Thema 8.32 and others. We are experienced in mountain racing and circuit racing and would like to help you. 

I am pleased to announce the the new "hard-chrome" rocker shafts to complement the newly introduced, bronze bushed rocker arms, are now in stock and available for immediate delivery.

The shafts are made from 1/4 inch wall, 4130 seamless tubing. Each unit is ground to "near net size", then hard-chrome plated, and finally centerless ground to its final dimension. This provides a ductile shaft (Rc 35) with a very hard outside shell (Rc72) for excellent wear characteristics. In addition, the final ground surface of the shaft has a very smooth and consistent finish, yet will hold oil for excellent lubrication qualities. Each shaft comes with removable end caps which can be removed for inspection and cleaning.

The new design shaft uses an improved oil delivery mechanism whereby oil is delivered directly to the bottom of the shaft, where the highest boundary interface loading takes place during valve actuation. Each rocker is fed by a single orifice, and the orifice has an additional "X" groove to assist in distributing the oil over the width of the internal bore of the rocker arm.

The shaft has been manufactured to standard factory size tolerances to ensure that it can be used with standard steel Fiat rocker arms, Scuderia Topolino bronze bushed, standard rocker arms or Scuderia Topolino, hard anodized, aluminum roller tip rocker arms.

While the full benefit of this shaft will only come to light with more aggressive camshafts, with attendant higher valve lift and spring pressures, even less aggressive engine combinations can benefit from the reduced parasitic friction of this new shaft, particularly if rocker arms with bronze bushes. or roller tipped rocker arms, are employed.

No more torn drive shafts at Fiat 600 and Fiat 850 ! 
Now as a set : 1 pair of drive shafts with universal joints as in Fiat Abarth 1000TC 1 series installed.                       
 For 16mm ( Fiat 600 differential ) or 18mm ( 1000TC lock or Fiat 850) sliding blocks available .                        

 

 


E600-24

Product no.: E600-24

Abarth Sticker 17x20cm

Product no.: ASA10

Abarth Sticker 17x20cm

In stock
can be shipped within 2 days

600-198

Product no.: 600-198

Valve - TCR/OTR exhaust valve 8mm stem

Product no.: 01-72

Valve - TCR/OTR exhaust valve 8mm stem . Exact duplicate of the original item

In stock
can be shipped within 2 days

Main bearings 0.10(0,25mm) A112 Abarth,54mm main brg.

Product no.: 02-13

Main bearings 0.10(0,25mm) A112 Abarth,54mm main brg.

bronze bushed rocker arm set (8)

Product no.: 01-37

bronze bushed rocker arm set (8) for fiat /A 112 Rocker Support.

In stock
can be shipped within 2 days

four bolt centre main cap for A 112 Abarth and Abarth 1000TC/R

Product no.: 01-270

four bolt centre main cap for A 112 Abarth and Abarth 1000TC/R. One thread must be drilled, the other one can be used from the oilgallery.The inner diameter of the cap must be individally machined to each block. 

In stock
can be shipped within 2 days
*
Prices incl. VAT, plus delivery